Wiper washer removal ?

[nicodache]

I got some schmutz stuck in my driver side windshiel wiper washer nozzle, and it's bately spraying anymore.

Anyone managed to remove their washer nozzle without removing the wiper arms and the cowl ?

 

[nicodache]

Taking this as a no

 

[luke_84]

Have you tried blowing it clear with compressed air?

 

[nicodache]

twice. both ways (from inside the engine bay out, and from the nozzle back in, with the hose disconnected).
No luck :/

 

[Robsyuk]

Needle. Poke the hole

 

[Guvna]

There is actually a handy little tool for that purpose, check ebay. Mine did the same thing a while back, once I stopped using the detergent additive it cleared itself. Must've been a dodgy batch, had to take the bottle out of the wifes Hyundai and clean it as it started growing some slimy shit that clogged hers totally.

 

[robo498]

There is actually a handy little tool for that purpose, check ebay. Mine did the same thing a while back, once I stopped using the detergent additive it cleared itself. Must've been a dodgy batch, had to take the bottle out of the wifes Hyundai and clean it as it started growing some slimy shit that clogged hers totally.

Any link to this item?

 

[Guvna]

Yeah why not

Car Windshield Spray Nozzle Cleaning Washing Needle Wiper Jet Washer Dredge Tool | eBay

Find many great new & used options and get the best deals for Car Windshield Spray Nozzle Cleaning Washing Needle Wiper Jet Washer Dredge Tool at the best online prices at eBay!

www.ebay.com.au

 

[robo498]

Yeah why not

Car Windshield Spray Nozzle Cleaning Washing Needle Wiper Jet Washer Dredge Tool | eBay

Find many great new & used options and get the best deals for Car Windshield Spray Nozzle Cleaning Washing Needle Wiper Jet Washer Dredge Tool at the best online prices at eBay!

www.ebay.com.au

Funny, that was the one I found and was going to buy unless you're was better! Turns out it was the same.

 

[Guvna]

lol Yeah expensive way to do it when finding a thin stiff bit of wire would suffice, but nice to have an actual tool ey

 

[nicodache]

I poked the hole to no avail. I suspect it's blocked by some s*t at the nozzle entrance (under the cowl) and not inside the nozzle.

Pending delivery of a new nozzle (don't want to remove the cowl and put it back in to figure out I didn't clean it properly, or is legit damaged, and have to remove cowl again).

Will keep you posted