Charlie's work in progress

lucavolta

Member
Joined
Aug 8, 2022
Messages
66
Location
Italy
Vehicle(s)
Subaru Levorg GT-S "STI Project"
Got the car back today, j pipe installed, tuned and a service.
The car now has 3 maps to select from. The dyno sheet shows comparison between map 1 and map 3 I believe.
Exhaust is louder under acceleration, nothing crazy, and a little drone but nothing that's gonna bother me. I think if I had the R400 exhaust it would be too loud. Can't wait for the weekend to go for a decent drive!

View attachment 2952
Very interesting!
 

charlie_ching

Active Member
Joined
Jul 2, 2023
Messages
100
Vehicle(s)
Levorg
I tried to record the car at idle before and after the j pipe install. But no good ha. The video sounded as if it was louder before the install. Was parked in my underground carpark, and recorded from the same location for each. I'll try post something that truly represents the sound when I get a chance
 

lerroy

Moderator
Staff Member
Joined
Jun 27, 2023
Messages
276
Location
Wanaka NZ
Vehicle(s)
VMG (A) Levorg
awesome !
how do you select the maps ? just via Si S# or ?
 

charlie_ching

Active Member
Joined
Jul 2, 2023
Messages
100
Vehicle(s)
Levorg
Exactly what I asked the tuner! But it's not the case.
So what you do is, hold the cancel button on the steering wheel. Then the rpm needle will move to 1, 2 or 3 depending on what map it is on. Then you use the cruise control toggle to change between 1, 2 and 3. Then press cancel again, or just leave it and it will select whatever map you are on. And I can change the boost for each map too. By holding down on the cruise control toggle, then the boost gauge on the dash will jump to what boost it is set to. Then you can toggle that with the cruise control toggle. I can't set the boost higher than what the tuner set for each map, only lower it.
 
Top