How to remove E brake cover?

[Matt_GT_AUS]

Hi All,

Looking to use the vacant switch area next to the E brake (opposite the hill assist button).
I'm going to install a garage remote button in this position.

Can anyone give me details of how to remove the cover?
I thought it was supposed to pull off but I don't want to break anything.

Any advice would be great.

Thanks in advance
Matt

 

[SkyBeam]

You are right. It just pulls off.
Carefully lift it upwarts from both sides. There are only plastic clips which hold it in place. Nothing will break. Just make sure you don't scratch the edges when pulling.

I just created a couple of pictures for you where you can see the clips underneath. See here.

Note: This if from the MY16 Levorg which has the traction control button on the opposite end of the hill-holder button but I guess the clips were not changed at all.

 

[Matt_GT_AUS]

Thanks SkyBeam - Much appreciated!!!!

 

[AKKO]

Doing the same, bought the OEM button for that spot so will look factory!